Removing The Mower; Installing The Mower - Toro TimeCutter SS 4225 Operator's Manual

Removing the Mower

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest position.
4. Remove the hairpin cotter from the front support rod
and remove the rod from the deck bracket
3
Figure 56
1. Front support rod
2. Locking nut
5. Carefully lower the front of the mower deck to the
ground.
6. Lift the mower deck and hanger brackets clear of
the rear lift rod and lower the mower carefully to the
ground (Figure 57).
ARK
(Figure 56).
2
1
G014635
3. Deck bracket
2 2
1
1. Mower deck
2. Hanger bracket
7. Slide the mower deck rearward to remove the mower
belt from the engine pulley.
8. Slide the mower deck out from underneath the
machine.
Note: Retain all parts for future installation.

Installing the Mower

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest position.
5. Lift the rear of the mower deck and guide the hanger
brackets over the rear lift rod
6. Attach the front support rod to the mower deck with
the clevis pin and hairpin cotter
7. Install the mower belt onto the engine pulley.
42
2 2
3 3
G005077
Figure 57
3. Rear lift rod
(Figure 57).
(Figure 56).
ARK