Toro TimeCutter SS 4225 Operator's Manual page 38

3. Measure from the tip of the blade to the flat surface
(Figure 44).
1
2
Figure 44
1. Blade (in position for measuring)
2. Level surface
3. Measured distance between blade and the surface (A)
4. Rotate the same blade 180 degrees so that the opposing
cutting edge is now in the same position
1
Figure 45
1. Blade (side previously measured)
2. Measurement (position used previously)
3. Opposing side of blade being moved into measurement
position
5. Measure from the tip of the blade to the flat surface
(Figure 46).
Note: The variance should be no more than 3 mm
(1/8 inch).
G014973
3
(Figure
3
2
G014974
1. Opposite blade edge (in position for measuring)
2. Level surface
3. Second measured distance between blade and surface (B)
A. If the difference between A and B is greater than
3 mm (1/8 inch), replace the blade with a new
blade; refer to
Installing the Blades (page
45).
Note: If you replace a bent blade with a new one
and the dimension obtained continues to exceed 3
mm (1/8 inch), the blade spindle could be bent.
Contact an Authorized Toro Dealer for service.
B. If the variance is within constraints, move to the
next blade.
6. Repeat steps
38
1
3
2
Figure 46
Removing the Blades (page 39)
39).
1 through 5 for each blade.
G014973
and