Clearing Blockages - Vax VCC-05 User Manual

Maintenance
HEPA Pre-motor filter (Model VCC-07 only)
Turn off the vacuum cleaner and unplug it from the electrical outlet.
Unclip the retainer clip on
the top of the vacuum
cleaner and lift up to gain
access to the dirt container
department.

Clearing blockages

WARNING: To reduce the risk of injury, the power cord must be disconnected before performing maintenance
or troubleshooting checks.
7
(Keep your Vax as good as new)
The HEPA pre-motor filter
is found in the centre of
the dirt container.
Rotate the filter clockwise
to remove.
Turn vacuum cleaner off and disconnect the power plug
from the electrical outlet.
The flexible hose can be disconnected from the vacuum
cleaner by rotating anti-clockwise and pulling away
from the machine. Remove any blockages found then
reconnect the hose.
Gently tap the filter against
the side of the rubbish
bin to remove excess dirt.
The filter may then be
rinsed in cool water.
Allow to thoroughly air
dry before replacing.
Replace the filter every
3-6 months depending on
usage or when the filter
becomes discoloured.
Vax Service line:
NOTE: Do NOT use any
detergents or boiling water
to wash the filter.
Replace the HEPA filter
back in the machine
before use.
Ensure filter is thoroughly
dry before replacing after
washing.
AU: 1300 361 505
NZ: 0800 800 900
vax