K 2.35 High Pressure Washer Operator Manual Overview ................ 2 Precautions ..............2-4 Assembly Instructions ........... 4 Operating Instructions ........... 5 Using the Accessories ........... 6 Working with Detergents ..........7 Shut Down and Clean-Up ..........8 Taking a Break ............... 8 Maintenance Instructions ..........
OVERVIEW High Pressure Washer Machine includes 1. On/Off switch 7. High/Low pressure nozzle 2. Connector for detergent suction tube 8. Trigger gun 3. High pressure outlet 9. Trigger gun safety lock 4. Water inlet with integral water filter 10. High pressure hose 5.
IMPORTANT PRECAUTIONS – Read First! Safety Warnings GROUNDING INSTRUCTIONS When using this product basic precautions This product must be grounded. If it should should always be followed: malfunction or breakdown, grounding provides • Read all the instructions before using the a path of least resistance for electric current to product.
IMPORTANT PRECAUTIONS – continued Water Supply (Cold Water Only) • Never use the pressure washer to draw in • Water hose must be at least a 1/2 inch or 5/8 inch in diameter. water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc. •...
OPERATING INSTRUCTIONS Step 1 Step 2 Connect the high pressure hose to the unit’s high Insert the High/Low pressure nozzle into pressure outlet. the trigger gun. Press in against the spring tension and twist into the locked position. Step 3 Step 4 Connect garden hose to unit’s water inlet.
USING THE ACCESSORIES High/low pressure nozzle Vario power nozzle Wash brush This nozzle features two positions. The high setting provides a steady powerful 25° high pressure spray pattern, for general cleaning. The low setting creates a wider 40° low pressure pattern. Turn the wand nozzle clockwise for high pressure.
WORKING WITH DETERGENTS Kärcher Pressure Washers operate at two pressures. The high pressure is used for cleaning, you cannot apply detergents when working at high pressure. To apply detergents you must be operating at low pressure. Step 1 Step 3 Install the High/Low pressure nozzle.
SHUTTING DOWN & CLEAN-UP Step 1 Step 2 Step 3 Step 4 Remove detergent suction Turn the switch to Turn off the water Press trigger to tube from jug and insert into off (0) position and source. release water 1 gallon (5 L) of fresh water. unplug cord from pressure.
WINTERIZING AND LONG-TERM STORAGE 1. Disconnect all water connections. 4. Store the machine and accessories in a room which does not reach freezing 2. Turn on the machine for a few seconds, until temperatures. DO NOT store near furnance the water which had remained in or other sources of heat as it may dry out the pump exits.
Kärcher Pressure Wash or Degreaser, place detergent suction tube directly into OPTIONAL CLEANING Optional cleaning accessories are available to further enhance your cleaning capabilities: For details call 1-800-465-4980 or visit www.karcher.ca • Sandblasting Attachment • Dirt Blaster • Water Siphon Kit •...
TROUBLESHOOTING Disconnect the machine from the power source before making any repairs. ymptom Cause Solution Motor will not start. On/Off switch is in the “OFF” Turn switch to the “ON” (O) position. (I) position. Power cord is not plugged in. Plug in power cord.
Page 12
Water seals are damaged or worn. Call Customer Service. Oil seals are damaged or worn. Call Customer Service. Oil Drip. 1-800-537-4129 If you encounter any additional difficulties not listed, please call Customer Service at 1-800-465-4980 for help, or visit www.karcher.ca...