Checking The Turn Signal/Hazard Relay - Yamaha YZF-R6(V) 2006 Service Manual

3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between "3" and "4")
Headlight relay (dimmer)
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between "3" and "4")
Radiator fan motor relay
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between "3" and "4")
ELECTRICAL COMPONENTS
ET2C01021
CHECKING THE TURN SIGNAL/HAZARD
RELAY
1. Check:
• Turn signal/hazard relay input voltage
Out of specification → The wiring circuit from
the main switch to the turn signal/hazard re-
lay coupler is faulty and must be repaired.
Turn signal/hazard relay input
voltage
DC 12 V
M MMM M MMM M M MMM
a. Connect the pocket tester (DC 20 V) to the
turn signal/hazard relay terminal as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
brown "1"
• Negative tester probe →
ground
b. Turn the main switch to "ON".
c. Measure the turn signal/hazard relay input
voltage.
L LLL L LLL L L LLL
2. Check:
• Turn signal/hazard relay output voltage
Out of specification → Replace.
Turn signal/hazard relay output
voltage
DC 12 V
M MMM M MMM M M MMM
a. Connect the pocket tester (DC 20 V) to the
turn signal/hazard relay terminal as shown.
8-100
M M MMM M M MMM M
L L LLL L L LLL L
M M MMM M M MMM M
M MMM M MMM
L LLL L LLL
M MMM M MMM