Checking The Coolant Level - Yamaha YZF-R6(V) 2006 Service Manual

NOTE:
Check that the projection "a" on the EXUP valve
pulley contacts the stopper "b" (fully open posi-
tion). If the projection does not contact the stop-
per, adjust the EXUP cable free play.
a
b
L LLL L LLL L L LLL L
3. Check:
• EXUP cable free play (at the EXUP valve pul-
ley) "a"
Out of specification → Adjust.
EXUP cable free play (at the
EXUP valve pulley)
1.5 mm (0.06 in) or less
4. Adjust:
• EXUP cable free play
M MMM M MMM M M MMM M
a. Loosen the locknuts "1" and "2".
b. Turn the adjusting bolt "3" in direction "a" or
"b" until the specification.
Direction "a"
Free play is increased.
Direction "b"
Free play is decreased.
EXUP cable free play (at the
EXUP valve pulley)
c: 1.5 mm (0.06 in) or less
c. Tighten the locknut "1" to specification.
L LLL L L LLL L L LLL L
a
M MMM M M MMM M M MMM M
d. Turn the adjusting bolt "4" in direction "a" or
"b" until the specification.
Direction "a"
Free play is increased.
Direction "b"
Free play is decreased.
LLL
e. Tighten the locknut "2" to specification.
f. Repeat steps (2) and (3).
L LLL L LLL L
5. Install:
• EXUP valve pulley cover
MMM
EAS21110

CHECKING THE COOLANT LEVEL

1. Stand the vehicle on a level surface.
NOTE:
• Place the vehicle on a suitable stand.
• Make sure the vehicle is upright.
3-17
Locknut (EXUP cable adjusting
bolt)
7 Nm (0.7 m·kg, 5.1 ft·lb)
EXUP cable free play (at the
EXUP valve pulley)
d: 1.5 mm (0.06 in) or less
Locknut (EXUP cable adjusting
bolt)
7 Nm (0.7 m·kg, 5.1 ft·lb)
1
c
d
2
L LLL L L LLL L L LLL L
EXUP valve pulley cover bolt
(front side)
8 Nm (0.8 m·kg, 5.8 ft·lb)
EXUP valve pulley cover bolt
(rear side)
7 Nm (0.7 m·kg, 5.1 ft·lb)
ENGINE
3
a
b
a
b
4
L LLL L LLL