Adjusting The Throttle Position Sensor (For Throttle Cable Pulley); Installing The Throttle Body Joints - Yamaha YZF-R6(V) 2006 Service Manual

1
b. Check that the throttle valves are fully closed.
c. Connect the throttle position sensor coupler
to the throttle position sensor.
d. Connect the digital circuit tester to the throttle
position sensor.
• Positive tester probe
white terminal "1"
• Negative tester probe
black/blue terminal "2"
Digital circuit tester
90890-03174
Model 88 Multimeter with ta-
chometer
YU-A1927
e. Measure the throttle position sensor voltage.
f. Adjust the throttle position sensor angle so
that the voltage is within the specified range.
Output voltage
0.635–0.645 V
g. After adjusting the throttle position sensor an-
gle, tighten the throttle position sensor
screws "3".
3
L LLL L LLL L L LLL L
Y/B Lg/R
2
2
1
3
L LLL L L LLL L L LLL L
ET2C01008
ADJUSTING THE THROTTLE POSITION
SENSOR (FOR THROTTLE CABLE PULLEY)
1. Check:
• Throttle position sensor (for throttle cable pul-
ley)
Refer to "CHECKING THE THROTTLE PO-
SITION SENSOR (FOR THROTTLE CABLE
PULLEY)" on page 8-107.
2. Adjust:
• Throttle position sensor angle
M MMM M MMM M
a. Connect the throttle position sensor coupler
to the throttle position sensor.
b. Connect the digital circuit tester to the throttle
position sensor.
• Positive tester probe
blue terminal "1"
• Negative tester probe
black/blue terminal "2"
c. Measure the throttle position sensor voltage.
d. Adjust the throttle position sensor angle so
that the voltage is within the specified range.
e. After adjusting the throttle position sensor an-
gle, tighten the throttle position sensor
screws "3".
LLL
L LLL L LLL L
ET2C01009

INSTALLING THE THROTTLE BODY JOINTS

1. Install:
• Throttle body joints "1"
7-11
THROTTLE BODIES
M MMM M M MMM M M MMM M
Digital circuit tester
90890-03174
Model 88 Multimeter with ta-
chometer
YU-A1927
Output voltage
0.630–0.730 V
3
L LLL L L LLL L L LLL L
M MMM M MMM
2
1
3
L LLL L LLL