Konica Minolta bizhub 3301P User Manual page 83

Use
NPA Mode
Off
Auto
Network Buffer
Disabled
Auto
3KB to [maximum size
allowed]
Mac Binary PS
On
Off
Auto
Standard Network Setup OR
Network [x] Setup
Reports
Network Card
TCP/IP
IPv6
Wireless
AppleTalk
User's Guide
To
Set the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol.
Notes:
• Auto is the factory default setting.
• Changing this setting from the control panel and then exiting the menus
causes the printer to restart. The menu selection is then updated.
Set the size of the network input buffer.
Notes:
• Auto is the factory default setting.
• The value can be changed in 1-KB increments.
• The maximum size allowed depends on the amount of memory in the
printer, the size of the other link buffers, and whether Resource Save is set
to On or Off.
• To increase the maximum size range for the Network Buffer, disable or
reduce the size of the parallel, serial, and USB buffers.
• Changing this setting from the control panel and then exiting the menus
causes the printer to restart. The menu selection is then updated.
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
• Auto is the factory default setting.
• Off filters print jobs using the standard protocol.
• On processes raw binary PostScript print jobs.
Display and set the printer network settings.
Note: The Wireless menu appears only when the printer is connected to a
wireless network.
- 83 -