Table of Contents
Advertisement
Interior
Designs
1
Shelves
Fresh Food Compartment and Door
The fresh food compartment also may be equipped with
adjustable, SpiU-Catcher
TM
shelves. These shelves have a
Elevator
TM
Shelf
spill retainer edge for easy clean up.
The Elevator
TM
shelf is equipped with a spill-retaining edge
and the Easy Glide slide-out feature. It can be adjusted up
In some models, these shelves have the slide out feature.
or down without unloading. To slide out, grasp the front of
To slide out, simply grasp the front of the shelf and pull.
the shelf and pull forward. Push the shelf in to return to
Gently push in to return the shelf to the original position.
original position.
To adjust the Elevator
TM
shelf: Pull out the knob on the
crank handle. Rotate the crank clockwise to raise the shelf,
and counterclockwise to lower the height of the shelf.
To remove: To remove the Elevator
TM
shelf for occasional
cleaning, completely unload the shelf and pull the shelf for-
ward. When the shelf stops, press up on the tabs located
underneath its outside edges, then continue pulling for-
ward, clear of the frame.
To replace: Align the shelf to the frame and push it all the
These shelves can be moved for varying food storage
way back. It is not necessary to depress the tabs for rein-
needs.
stallation.
To remove a shelf:
In ordinary use, the Elevator
TM
shelf frame assembly does
NOT require removal. Though unlikely, and not rccom-
• completely unload the shelf
mended, the correct removal procedure is as follows:
• slightly lift up the rear of the shelf
• Unload the shelf completely.
• pull the shelf straight out
• Slide the shelf forward about two inches and manually
move the two rear latches toward the shelf center.
To lock a shelf into another position:
• While supporting the entire shelf and frame from
• tilt up the front edge of the shelf
underneath,
lift slightly and rotate the assembly
• insert the hooks into the desired frame openings
approximately 30° to allow the rear mechanism to clear
the vertical rear side rails.
• let the shelf settle into place
• The entire assembly can then be moved forward and
• be sure the shelf is securely locked at the rear befor(
clear of the refrigerator compartment,
reloading
• To reinstall, reverse the removal procedure. Be sure the
shelf is in a level position. When the sliding shelf is
pushed to the rear, it will reposition the rear latches to
their correct operating position.
VERTICAL RAILS
,REAR
FRAME
SLIDE OUT SHELF
(Style may vary)
Advertisement
Table of Contents
