Changing The Speaker Volume; Changing The Ring Tone Volume - Sennheiser VMX OFFICE Instruction Manual

If the headset leaves the transmission
range of the base station
• The sound quality deteriorates before
the connection finally breaks down.
• The PHONE LED
that the headset is out of the base
station's transmission range.
• The headset LED
every 5 seconds, indicating that the
headset is out of the base station's
transmission range and in standby
mode.
If you re-enter into the transmission
range within 40 seconds, a ring tone is
heard in the headset. To resume the call:
Press the headset hook button.
If the headset leaves the transmission
range of the mobile phone
• The sound quality deteriorates before
the connection finally breaks down.
• Your mobile phone or Bluetooth
device displays the loss of connection.
• A failure beep is heard in the headset.
• Please refer to the manual of your
mobile phone or Bluetooth device
for information on whether the call
is automatically transferred to the
mobile phone or Bluetooth device or
requires an acknowledgement to do
so.
during a call:
»
turns off to indicate
flashes blue twice
during a call:

Changing the speaker volume

Press the volume up button
volume down button
The speaker volume is changed by
one step. The speaker volume can be
adjusted in 8 steps. The factory
setting is 4. When the minimum or
maximum volume is reached, a beep
is heard in the headset.
In addition, the adaptive intelligence
"learns" your preferred settings and
adjusts the volume automatically.
If you close the headset's microphone
boom, the current volume setting is
saved.

Changing the ring tone volume

Press the volume up button
volume down button
headset is in standby mode (no
active call).
The ring tone volume is changed by
one step. The ring tone is played once
in the set volume. The set volume is
saved.
The ring tone volume can be adjusted
in 8 steps. The factory setting is
step 4.
or the
during a call.
or the
while the
19