A Fault Indicator Light Comes On But The Wash Programme Continues As Normal - Miele Softtronic W 418 Operating Instructions Manual

A fault indicator light comes on but the wash programme con-
tinues as normal.
Fault indicator
The Check drain
light flashes.
The Check inlet light
flashes.
The Excess deter-
gent check light co-
mes on.
The Main wash indi-
cator light is flash-
ing in the
programme se-
quence display.
The Anti-crease/Fin-
ish indicator light
flashes in the
programme se-
quence display.
A To switch off the fault indicator: switch the washing machine off with the I-ON/
0-OFF button and turn the programme selector to Finish .
Possible cause
The drain outlet is
restricted.
The water inlet is
restricted.
The filter in the wa-
ter inlet hose is
dirty.
Excessive foam
has built up during
washing.
There is a fault.
The position of the programme selector was altered after
the start of the programme. Turn the programme selector
back to the programme previously chosen.
Problem solving guide
Remedy A
Clean the fluff filter and the drain
pump as described in "Problem
solving guide - Opening the door in
the event of a blocked drain outlet
and/or power failure".
Check whether
– the stopcock is opened wide
enough.
– the inlet hose is kinked.
Clean the filter.
Use less detergent next time and
follow the manufacturer's instruc-
tions on dosage given on the pack-
aging.
Start the programme again.
If the fault indicator occurs again,
contact the Service Department.
39