A Fault Indicator Light Comes On But The Wash Programme Continues As Normal - Miele W 163 Operating Instructions Manual

A fault indicator light comes on but the wash programme
continues as normal.
Problem
The Check drain
light flashes.
The Check inlet light
flashes.
The Excess
detergent light is
flashing.
The Main wash
indicator light is
flashing in the
programme
sequence display.
The Finish indicator
light is flashing in
the programme
sequence display.
ATo switch off the fault indicator: turn the washing machine off with the
I-ON/0-OFF button and turn the programme selector to Finish .
Possible cause
The drain outlet is
restricted.
The water inlet is
restricted.
The filter in the water
inlet hose is dirty
Excessive foam has
built up during
washing.
There is a fault.
The position of the programme selector was altered
after the start of the programme. Turn the programme
selector back to the programme previously chosen.
Problem solving guide
Remedy A
Clean the fluff filter and the drain
pump as described in "Problem
solving guide – Opening the lid in
the event of a blocked water
outlet and/or a power failure".
Check whether
– the stopcock is opened wide
enough.
– the inlet hose is kinked.
Clean the filter.
Use less detergent next time and
follow the manufacturer's
instructions on dosage given on
the packaging.
Start the programme again.
If the fault indicator occurs again,
contact the Service Department.
39