Color Calibration - Brother HL-4150CDN User Manual

Control Panel
Factory Reset
You can partially reset the machine back to its default printer settings. The settings that will not be reset are
the Interface, Local Language, Reprint, Set Registration, Setting Lock, Secure Function
Lock 2.0 and the Network settings:
a
Press + or - to choose Reset Menu. Press OK.
b
Press + or - to choose Factory Reset. Press OK.
c
Press + to choose Reset.
Settings Reset
This operation will reset all the machine settings back to the settings that were set at the factory:
a
Disconnect the network cable from the machine; otherwise the network settings (such as IP address) will
not be reset.
b
Press + or - to choose Reset Menu. Press OK.
c
Press + and Cancel at the same time. Press OK after Settings Reset appears.
d
Press + to choose Reset.
e
Press + to choose Yes. The machine will restart automatically.

Color Calibration

The output density for each colour may vary depending on the environment the machine is in, such as
temperature and humidity. Calibration helps you to improve the colour density.
Note
If you print using the Windows
Use Calibration Data and Get Device Data Automatically are on. The default settings are on. See
Color Calibration on page 37.
If you print using the Macintosh printer driver, you need to perform the calibration using the Status Monitor.
After turning the Status Monitor on, choose Color Calibration from Control menu. See Status Monitor
on page 57 for how to turn the Status Monitor on.
Calibration
a
Press + or - to choose Color Correction. Press OK.
b
Press + or - to choose ColorCalibration. Press OK.
c
Press OK to choose Calibrate.
d
Press + to choose Yes.
®
printer driver, the driver will get the calibration data automatically if both
3
3
3
3
3
79