Table of Contents
Advertisement
Installation
Installation
Notes
• T he installation should be done by qualified service personnel or sysytem
installers.
• I f the ceiling material is not strong enough to hold the installation screws, the
camera may fall off. Reinforce the ceiling as needed.
• T ake care not to drop the product during installation. Do not allow anyone to stand
below the installation area.
1) Remove the dome cover and shield case from the main body by loosening
the three dome cover screws.
2) And then remove the main body from mounting bracket by the four main body screws.
Adjust the panning and tilting, rotating while watching the monitor
145°
170°
Pan Base
-170°
10
COLOR DOME CAMERA
Mounting Bracket
Main Body(Camera)
Dome Cover
73°
195°
Rotate Base
Tilt Base
User's Manual
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
• Pan Base moves by 170° to each side direction and 340° on the whole.
• Tilt Base covers total 146° angle(73°to each side).
• Angle range of Rotate Base is the same as that of Pan Base. But One side
range is 195° and another is 145°
2) Methods of adjustment
• The case of wall installation
After mounting the camera on a wall, adjusting the panning angle so that the
...
camera can face the direction to monitor when tilting.
And then adjust the tilting angle by rotating the tilt base.
...
Loosen the rotate base hold screw and adjust rotate base for the best
...
monitoring.
Tighten the rotate base hold screw.
...
• The case of ceiling installation
After mounting the camera on a ceiling, adjusting the panning angle for better
...
monitoring area by rotating the pan base.
And then adjust the tilting angle by rotating the tilt base.
...
Notes
• W hen adjusting the rotating angle, loosen rotate base holding screw as following
Figure A. And then tighten it again.
• W hen adjusting the tilting angle, just grip the tilt base and adjust tilting angle.
• W hen adjusting the panning angle, loosen pan base holding screws as the
following Figure B. And then tighten them again.
• 2 LEDs are paned in case of control Tilt angle(73°) to maximum but it is no
difference of visibility range performance.
Rotate Base Holding Screw
Pan Base Holding Screw (Color:Gold)
• I n case of adjusting the tilting, do not take the lens for preventing physical shocks.
Please take the Tilt Base
COLOR DOME CAMERA
Rotate Base Holding Screw
11
User's Manual
Advertisement
Table of Contents
