Incoming Call While In Programming Mode - Siemens optiPoint 300 basic Operation And Andministration Manual

Incoming call while in programming mode

Ignoring the call offer
Picking up the new call
You can continue to receive calls on your optiPoint 300 basic while
you are programming it. If call-waiting has been enabled, then the
incoming call will be audibly signalled by CW-tone, and you will
see the call-waiting symbol flashing on the display. However, the
caller's telephone number will not be shown.
If call-waiting has been disabled, then the caller will receive a busy
signal while you are working on your phone in programming
mode.
>>>_____
>>>_____
>>>_____
008972212345
008972212345
h
Alternately, use the
changes you have made to the settings.
Caller announced while in
programming mode
Turn down the offer of the
CW
new call
Programming mode
Caller announced while in
programming mode
Save your changed
?
settings
Caller's number is
displayed
Pick up handset
The call is now active
key to pick up the call without saving the
Operation
42