Table of Contents
Advertisement
Programming the unit
Programming the quick-dial keys
You can program your optiPoint 300 basic for the various ad-
vanced features supported.
To program these features, you must go into programming mode;
to start, press Service and then the function key you wish to pro-
gram. The optiPoint 300 basic telephone will enter programming
mode, with the programming mode symbol
with the currently programmed setting.
To break off programming at any time, simply press
changes you have made will be cancelled. Press
your programming changes; this will be acknowledged with an au-
dible signal.
The optiPoint 300 basic has fourteen quick-dial keys. For each of
those keys, you can assign a telephone number or an IP address.
You will be able to call them by simply pressing the key.
12 – 03 – 00
– – – – – –
4 – 0089_
12 – 03 – 00
Label the quick-dial key overlays with the appropriate
telephone number.
Idle mode
12 – 34
Press special function key
Service
"Service" to change to
service mode
Do not enter PIN
Press desired quick-dial
key (e.g. "4")
(Programming mode)
Quick-dial key is displayed;
enter desired number
? Save changes
Idle mode
12 – 35
Operation
displayed along
h
. Any
?
to confirm
38
Advertisement
Table of Contents
