Disassemble Av Module And Connector Board - Optoma EP756 Service Manual

4-6
EP757
SERVICE MANUAL

4-2 Disassemble AV Module and Connector Board

1. Turn over Bottom Housing and remove four screws from Bottom Housing.
2. Unscrew two screws of Label Connector Module to remove Label Connector Module and remove
two screws from Connector Cover Clamp. Take off Side Vent.
Introduction Fundamental Principle
Troubleshooting Function Test and Alignment Procedure
Mechanical Construction Procedure of Disassembly
Firmware Upgrading Procedure
Connector Cover Clamp
Function of Boards Specifications
DDC Key-In Procedure Appendix
Bottom Housing
Side Vent