Using The Remote Control Unit; Setting Up The System - Denon AVR-1404/484 Operating Instructions Manual

9

USING THE REMOTE CONTROL UNIT

Following the procedure outlined below, insert the batteries before using the remote control unit.
Using the remote control unit
30°
30°
Approx. 7 m
Inserting the batteries
q Remove the remote control w Insert the R6P/AA batteries properly,
unit's rear cover. as shown on the diagram.
NOTES:
• Use only R6P/AA batteries for replacement.
• Be sure the polarities are correct. (See the illustration inside the battery compartment.)
• Remove the batteries if the remote control transmitter will not be used for an extended period of time.
• If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact
with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.
• Have replacement batteries on hand so that the old batteries can be replaced as quickly as possible when the
time comes.
• Even if less than a year has passed, replace the batteries with new ones if the set does not operate even when
the remote control unit is operated nearby the set. (The included battery is only for verifying operation. Replace
it with a new battery as soon as possible.)
Point the remote control unit at the remote control
sensor as shown on the diagram at the left.
NOTES:
• The remote control unit can be used from a straight
distance of approximately 7 meters, but this
distance will shorten or operation will become
difficult if there are obstacles between the remote
control unit and the remote control sensor, if the
remote control sensor is exposed to direct sunlight
or other strong light, or if operated from an angle.
• Neon signs or other devices emitting pulse-type
noise nearby may result in malfunction, so keep
the set as far away from such devices as possible.
e Close the lid.
10

SETTING UP THE SYSTEM

• Once all connections with other AV components have been completed as described in "CONNECTIONS"
(see pages 5 to 8), make the various settings described below on the display.
These settings are required to set up the listening room's AV system centered around the this unit.
1
Set the slide switch to "AUDIO".
2
Use the following buttons to set up the system:
• System setup items and default values (set upon shipment from the factory)
System setup
Input the combination of speakers in your
system and their corresponding sizes
Speaker (SMALL for regular speakers, LARGE for
Configuration full-size, full-range) to automatically set the
composition of the signals output from the
speakers and the frequency response.
Subwoofer This selects the subwoofer speaker for playing
mode deep bass signals.
This parameter is for optimizing the timing with
which the audio signals are produced from the
Delay Time
speakers and subwoofer according to the
listening position.
Digital In This assigns the digital input jacks
Assignment for the different input sources.
NOTE:
• The system setup is not displayed when "HEADPHONE ONLY" is selected.
SYSTEM SETUP button
Press this to display the system setup on the display.
CURSOR buttons (•, ª, 0, 1)
Press this change what appears on the display.
ENTER button
Press this to switch the display.
Also use this button to complete the setting.
Default settings
Front Sp. Center Sp. Surround Sp.
Large Small Small
Subwoofer mode = Normal
Front & Sub Woofer Center Surround L & R
3.6 m 3.6 m
Digital
COAX OPTICAL
Inputs
Input
DVD/VDP TV/DBS
source
ENGLISH
Sub Woofer
Yes
3.0 m
9