Surround; Test Tone Button - Denon AVR-1404/484 Operating Instructions Manual

ENGLISH
13

SURROUND

Before playing with the surround function
• Before playing with the surround function, be sure to use the test tones to adjust the playback level from each
speakers. This adjustment can be performed from the remote control unit, as (described) below.
• The adjustment with the test tones is only effective in the DOLBY/DTS SURROUND modes.
The adjusted playback levels for the different surround modes are automatically stored in the memory of each
surround modes.
1
Set the DOLBY/DTS SURROUND (Dolby Pro
Logic II or Dolby Digital or DTS) modes.
(Main unit) (Remote control unit)
2
Press the TEST TONE button.
(Remote control unit)
Test tones are output from
the different speakers.
Use the channel volume
adjust buttons to adjust so
that the volume of the test
tones is the same for all
(Remote control unit)
the speakers.
NOTE: Please make sure the
position of the slide switch on the
remote control unit.
3
After completing the adjustment, press the
TEST TONE button again.
(Remote control unit)
18
1
1
"AUDIO"
2, 3
• After adjusting using the test tones, adjust the channel levels either according to the playback sources or to
suit your tastes, as (described) below.
1
Select the speaker whose level you want to
adjust.
(Main unit)
The channel switches as shown below each
time the button is pressed.
FL CNTR
NOTE: Please make
position of the slide switch on the
remote control unit.
2
Adjust the level of the selected speaker.
(Main unit)
Only adjustable when
the channel is
selected with the CH
VOL buttons on the
main unit.
2
Dolby Surround Pro Logic
2
1 2
1
Select the function to which the component
you want to play is connected.
Example: DVD
(Main unit)
(Remote control unit)
FR SR SL
SW
sure the "AUDIO"
1
Default setting of channel level is 0 dB.
The level of the selected speaker can be adjusted
within the range of +12 to –12 dB.
(Remote control unit)
II mode
2
1
4, 6 5, 7
5, 7
(Remote control unit)
2 1
2
2
The Dolby Surround Pro
Logic II Cinema or Music
mode can be chosen
directly by pressing the
CINEMA or MUSIC
button on the remote
control unit during
playback in the Dolby
Surround Pro Logic II
mode.
4, 6
5, 7