Read This First; Setting Up The Speaker Systems - Denon AVR-1404/484 Operating Instructions Manual

6

READ THIS FIRST

This A / V surround Receiver must be setup before use. Following these steps.
Step 1
(page 5 to 8)
Choose the location to setup the speakers and connecting the components.
Step 2
(page 9)
Next, insert the batteries into the remote control unit.
Step 3
(page 9 to 12)
Finally, setting up the system.
7

SETTING UP THE SPEAKER SYSTEMS

2 Speaker system layout
Basic system layout
• The following is an example of the basic layout for a system consisting of six speaker systems and a
television monitor:
Subwoofer
Front speaker systems
Set these at the sides of the TV or
screen with their front surfaces as flush
with the front of the screen as possible.
Center speaker system
Surround speaker systems
8 CONNECTIONS
• Do not plug in the AC cord until all connections
have been completed.
• Be sure to connect the left and right channels
properly (left with left, right with right).
• Insert the plugs securely. Incomplete connections
will result in the generation of noise.
• Use the AC OUTLET for audio equipment only.
Do not use them for hair driers, etc.
Connecting the audio components (1)
CD recorder or Tape deck
OUTPUT INTPUT
Connecting a tape deck
R L R L
Connections for recording:
R L R L Connect the tape deck's recording input jacks (LINE IN or REC) to this unit's tape
recording (CDR/TAPE OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck's playback output jacks (LINE OUT or PB) to this unit's tape
playback (CDR/TAPE IN) jacks using pin plug cords.
L
R L
R
R L
R L
Subwoofer jack
Connect the internal amplifier's
subwoofer to the subwoofer terminal.
(Refer to page 8.)
Decoder with 6-channel analog
output
ENGLISH
• Note that binding pin plug cords together with
power cords or placing them near a power
transformer will result in generating hum or other
noise.
• Noise or humming may be generated if a
connected audio equipment is used independently
without turning the power of this unit on. If this
happens, turn on the power of the this unit .
Power supply cord
AC 230V, 50Hz (ASIA model)
AC 220V, 50Hz (CHINA model)
AC 120V, 60Hz (TAIWAN R.O.C. model)
AC OUTLET
AC 230V 50Hz
SWITCHED
100W MAX.
SWITCHED TOTAL 120W MAX.
AC 120V 60Hz SWITCHED 100W MAX.
AC OUTLET AC OUTLET
for Taiwan R.O.C. model for Asia model
Connecting the AC OUTLTETS
AC OUTLET
• SWITCHED
(total capacity – 120 W – for Taiwan R.O.C. model)
(total capacity – 100 W – for Asia model)
The power to these outlets is turned on and off in conjunction with the
POWER operation switch on the main unit, and when the power is
switched between on and standby from the remote control unit.
No power is supplied from these outlets when this unit's power is at
standby. Never connect equipment whose total capacity is above 120
W for Taiwan R.O.C. model (100 W for Asia model).
NOTE:
Only use the AC OUTLET for audio equipment. Never use them for
hair driers, TVs or other electrical appliances.
5