PSC Falcon 310 User Manual page 26

Falcon Basics
16
The Falcon 32X will not function unless the battery-compartment cover is in
place and securely latched.
The battery pack should not be replaced in a dirty or harsh environment.
When the battery compartment cover is off, dust or moisture can potentially
cause damage. Falcon models 33x and 34x will not function unless the bat-
tery-compartment cover is in place and securely latched.
Falcon Models 34x
To replace the batteries for Falcon model
steps:
1. Turn the Falcon off.
2. If using the hand-strap rather than the pistol grip, detach the elastic
hand-strap by releasing its hook from the hand-strap connector at
the base of the unit.
3. Turn the cover latch dials to release the battery compartment cover.
Refer to
Figure 7 on page 18
• Using the lever, turn the left dial clockwise.
• Using the lever, turn the right dial counter-clockwise.
4. Pull the end of the exposed plastic ribbon in the battery compart-
ment until the batteries pop out.
5. Lay the plastic ribbon along the bottom of the battery compartment
with the end sticking out.
6. Find the positive (+) and negative (-) symbols on the
label.
Pack's
7. With the label side out, tilt the positive end of the pack into the
upper end of the battery compartment.
, complete the following
34X
for the location of the dials.
®
Falcon DOS Portable Terminals
NiMH Battery