Sound - Panasonic DMR-HWT250 Operating Instructions Manual

3D video is not output correctly.
• 3D video may be output correctly by changing
the following settings:
- "3D Type" of "3D Settings" (
- "Signal Format" (
playback)
• Check the settings of the connected TV.
• When a non-3D compatible amplifier/receiver is
connected between this unit and a TV, 3D video
is not output. ( 14)
• When the amplifier/receiver which is connected
between this unit and a TV is off, 3D video is not
output. ( 14)
• When "HDMI Audio Output" is set to "Off", 3D
video may not be output correctly. (
The same video is displayed in each left and
right half of the screen.
• This is a 3D programme of the Side-by-Side
type.
Change the setting as follows if connecting with
a 3D compatible TV:
1 Press [DISPLAY].
2 Select "3D Settings", then press [OK].
3 Select "Side by side" in "Signal Format", then
press [OK].
62, 68)
39, 3D settings during
69)

Sound

No sound.
Distorted sound.
• Check the connections. (
• Check the settings of the connected TV, etc.
• Press [AUDIO] to select the audio. (
• To output audio from a device connected with an
HDMI cable, set "HDMI Audio Output" to "On".
( 62, 69)
Cannot change audio channel.
• You cannot change the audio channel if "Digital
Audio Output" is set to "Bitstream". (
Troubleshooting
13)
23, 38)
67)
79
SQT0816