For Remote Control Rm-Pj1001; Preparation - Sony VPH-D50HTU Installation Manual

For Remote Control RM-PJ1001

Preparation

All adjustments, except focusing the lens and adjusting flapping of the
lens, can be made with the supplied remote control RM-PJ1001.
Normally, the adjustment keys on the remote control are inoperable to
prevent accidental adjustments. Cancel the protection before adjusting.
Since the remote control uses infrared, you can use it without a wire.
However, in order to correctly control the projector, you should connect
the remote control to the projector with the supplied remote control cable.
1
Insert three of the supplied AA size batteries (R6) with the polarities
lined up correctly.
For details, see "Battery installation" on page 36 (GB).
2
Connect the remote control to the projector.
See "Connecting the remote control to the projector" on page 37 (GB).
3
Make sure that the COMMAND ON/OFF switch on the remote control
is set to ON.
4
Turn on the MAIN POWER switch on the projector, and then press the
ON key on the remote control.
5
Open the panel cover of the adjustment keys.
PATTERN
Adjustment keys
Slide the cover while pushing it.
Lift the cover slightly to open.
LIGHT
MUTING STATUS COMMAND
PIC AUDIO OFF ON OFF ON STANDBY ON
RGB CENT
NORMAL DOT PHASE SIZE SHIFT R MEMORY MENU
APA
LCD LENS CONTROL
PATTERN ZOOM SHIFT FOCUS B
INPUT SELECT
VIDEO SYS SET BLKG RESET FUNCTION ENTER
SELECT
VIDEO/S VIDEO
PICTURE CONTROL
A B C D
BRIGHT CONTR POSITION
SWITCHER/VIDEO MEMORY/INDEX
1 2 3 4
SHARP HUE COLOR VOL
5 6 7 8
SW NO/
VIDEO MEMORY
9 10/0(ALL) OFF/GROUP
SWITCHER INDEX
CUT OFF ADJ W/B FOCUS
R G B R G B BIAS GAIN MG FOCUS LENS
REGISTRATION POSITION
CENT SIZE LIN SKEW BOW KEY PIN ZONE
Before adjustment
COMMAND
ON/OFF
switch
ON
35
(GB)