Buell 2009 XB Series Service Manual page 557

HOME
3. See Figure 6-117. Verify that the interactive exhaust cable
(3) is routed behind the frame lug (1) before installing air
intake cover.
4. See Figure 6-116. Mate exhaust actuator harness con-
nector [165] beneath main harness (6) under seat.
5. Install ground bolt through main battery ground cable and
actuator ground wire. Tighten to 48-72 in-lbs (5.4-8 Nm).
6. Install fuse block on the battery tray.
7. Connect negative battery cable to battery terminal.Tighten
fastener to 72-96 in-lbs (8-11 Nm).
8. Install intake cover. Tighten fasteners to 12-36 in-lbs (1.4-
4 Nm).
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
9. Install seat.
sm00434
1
3
1. Frame lug
2. Wire harness
3. Cable
Figure 6-117. Correct Cable Routing Behind Frame Lug
(Typical)
2009 XB Service: Electrical 6-97
2