Unpacking Instructions; Mounting; Orientation - Samsung SP0401N Product Manual

4.2

Unpacking Instructions

(1) Open the shipping container of the SpinPoint P80.
(2) Lift the packing assembly that contains the drive out of the shipping container.
(3) Remove the drive from the packing assembly. When you are ready to install the drive, remove it from
the ESD (Electro Static Discharge) protection bag. Take precautions to protect the drive from ESD
damage after removing it from the bag.
CAUTION: During shipment and handling, the anti-static ESD protection bag
prevents electronic component damage due to electrostatic discharge. To avoid
accidental damage to the drive, do not use a sharp instrument to open the ESD
protection bag.
(4) Save the packing material for possible future use.
4.3

Mounting

Refer to your system manual for complete mounting details.
(1) Be sure that the system power is off.
(2) For mounting, use four 6-32 UNC screws.
CAUTION: To avoid stripping the mounting-hole threads, the maximum torque
applied to the screws must not exceed 8.0 Kg-cm (6.95 inch-pounds).

4.3.1 Orientation

Figure 4-2 shows the physical dimensions and mounting holes located on each side of the drive. The
mounting holes on SpinPoint P80 hard disk drives allow the drives to be mounted in any direction.
SpinPoint P80 Product Manual Rev. 01
INSTALLATION
13