Home Menu Displays - Panasonic AJ-HD3700H Operating Instructions Manual

HOME menu displays

∑ Audio signal display area
format used.)
∑ Display lamps
How to display the ≥AUDIO IN menu:
menus:
AUDIO IN
≥AUDIO OUT menu:
(Either 8 or 4 channels will be automatically displayed depending on the
Use this to adjust the level of the input audio signals on the AUDIO
IN menu. Alternatively, it is used to adjust the level of the audio
playback output signals on the AUDIO OUT menu.
Press the L/R buttons to select the audio channel whose signals
are to be output from the AUDIO MONITOR L/R connectors and
HEADPHONES jack.
These display the type of input signals of each channel.
The F1 (CH-1) to F6 (DIGITAL) [or F1 (CH-1) to F13 (CH-8) for 8
channels] on the AUDIO IN PCM INPUT SELECT menu are se-
lected using the F9 (CH-MIX) key on the AUDIO IN CUE INPUT
SELECT menu.
[---- ANA:
CH1 AES:
CH1 SER:
{---- INT:
[---- LINE:
CUE MIX:
{---- AUTO: This is always used for digital channel backup pur-
SYSTEM: This indicates the video system format which was set
TAPE:
AUDIO OUT
Signals from the ANALOG INPUT connectors.
Signals from the DIGITAL AUDIO INPUT connectors.
Signals from the serial V/A input connectors.
Signals from the internal signal generator.
Signals from the CUE IN connector.
CH1 to CH8 signals selected by CUE MIX setting.
poses.
on the SETUP/SYSTEM menu.
1080_59i
525_59i
1080_23psf
1080_24psf
720_59p
1080_50i
This indicates the format of the playback tape.
"¢¢¢¢¢¢¢¢" appears in the EJECT mode.
If a section is unrecorded or if the format of a section
cannot be identified, the lamp blinks while the display
of the format identified up to the section concerned is
retained.
1080_59i, 1080_60i
1035_59i, 1035_60i
525_59i
1080_23p, 1080_24p
720_59p, 720_60p
1080_50i
≥AUDIO IN PCM INPUT SELECT menu:
#
AUDIO IN F6
≥AUDIO IN CUE INPUT SELECT menu:
# F7
AUDIO OUT
– 8 –