Panasonic AJ-HD3700H Operating Instructions Manual page 16

HOME menu
∑ Pre-read editing
(1) Set the pre-read function to ON by pressing the F key and F11 key (PREAD A) or F12 key
(PREAD V) together.
(2) Perform the connections for pre-read editing as shown in the figure below.
(3) Proceed with pre-read editing in the desired insert editing mode.
(4) Restore the original connections upon completion of the editing.
(5) Press the F11 or F12 key to set the pre-read function to OFF.
(6) Check that there are no loop connections.
ONoteN
During pre-read operations, the SD SDI MONITOR and AUDIO MONITOR connectors function
as monitoring connectors, and the input signals are output from the IN point to the OUT point in
their original state.
Further, the preread monitor function will not work when the monitor MIX function has been set
to ON. To use the function, set MIX to OFF.
Video
Source
Audio
Source
PREAD V
ON
PREAD A
ON
Digital video output
Digital video input
Video
Switcher
Digital
~
AC IN FUSE
125V 5A
or
Audio
analog
Mixer
audio
input
Digital or analog audio output
Connections for pre-read editing
– 16 –
SD SDI IN SD SDI OUT
REF IN VIDEO OUT WFM SD SDI
1 2 3 IN OUT1 IN
HD SD
ON ON
(SUPER)
75 Ω 75 Ω ACTIVE ACTIVE
THROUGH THROUGH
CH CH CH CH
1 3 INPUT 5 7 OUT2
OFF OFF
π π π π
2 4 6 8
SD
SPARE MONITOR
HD SD
CH 1 3 CH OUTPUT CH 5 7 CH
2 π 4 π 6 π 8 π
(SUPER)
REF OUT DIGITAL AUDIO
REMOTE REMOTE REMOTE V/A
IN OUT IN/OUT CONTROL
CONTROL
PANEL
AUDIO IN TIME CODE
PUSH H 1 PUSH H 2 PUSH H 3 PUSH H 4 PUSH H 5 PUSH N OUT
AUDIO OUT MONITOR
CH 1 CH 2 CH 3 CH 4 CUE L R
SIGNAL
GND
HD SDI
OUT OUT
1 3
OUT
2
MONITOR
(SUPER)
RS-232C
PA RALLEL
IN/OUT
(50P)