Yanmar 3JH5E Operation Manual page 36

PRODUCT OVERVIEW
Setup screen access and control
(Setting the temperature and pressure units and engine speed pulse)
1
4 1
Select
Engine type select
1
4
Select
Exit setup
Return to previous
5
page LCD control
28
2
Scroll
2 3
Scroll Select
Imperial Metric
2 3
Scroll Select
P 10.29
Use the buttons on the bottom of the LCD
display to set the instrument panel.
Press the left button to switch between displays.
Press and hold both buttons until
1
"SET UP" appears.
Press the left button to set the units for
2
the temperature and pressure display.
Setting the temperature and pressure units
The display says "UNIT".
Next, press the right button to select
1
Metric units (°C, BAR). The display says
"METRIC".
Press the left button to switch to Imperial
2
units (°F, PSI). The display says "ENGL".
Press the right button to select and go
3
back to the "UNIT" screen.
Press the left button and go to the next
4
screen "ENGINE".
Confirm that the display says "ENGINE".
Pressing the right button shows the screen
for the engine speed pulse setting.
Setting the engine speed pulse value
Confirm that the display says
1
"ENGINE". Press the right button and
"P10.29" appears..
Note: This engine panel is pre-set to a speed
pulse of P10.29.
Confirm that the display says "P10.29".
2
If not, press the left button and change the
set value.
After confirming the above, press the right
3
button to return to the "ENGINE" screen.
Press the left button again to go from the
4
"ENGINE" screen to the "EXIT" screen.
After confirming the display, press the
5
right button to re-start the panel and return
to the hourmeter display.
JH Series Operation Manual
043719-00E00