Ram Module - Panasonic CF-M34 Series Reference Manual

RAM Module

RAM Module
Hooks
Use a RAM module meeting the RAM module specifications below. If a module is used
that does not meet the specifications, there are cases in which data may become unus-
able or the computer may not operate properly.
RAM module specifications
144 pins, SO-DIMM, 3.3 V, SDRAM, PC133 Compliant
Only a RAM card designed for PC133 can be added
(Max. 512 MB).
CAUTION
RAM modules are extremely sensitive to static electricity. There are cases where
static electricity generated by the human body has adversely affected such mod-
ules. In addition, it is easy to damage the RAM modules or internal components of
the computer. Therefore, when inserting or removing a RAM module, handle the
module with extreme care.
Inserting/Removing the RAM Module
1
Power off your computer
Do not shut down using the suspend or hibernation mode.
Disconnect the AC adaptor.
2
Remove the battery pack
3
Remove the cover
Remove the ten screws with a screwdriver, and remove the bottom cover
as shown in the illustration.
4
Inserting the RAM module
Slide in the module at an angle.
Snap the module into place by pushing down on it.
Removing the RAM module
Open the left and right hooks.
Gently remove the RAM module from the slot.
5
Put the cover back into place, then fasten screws
NOTE
Whether the RAM module is properly recognized or not can be con-
firmed in [Information] of the Setup Utility (
RAM module is not recognized, power off the computer and insert it
again.
( "Starting Up/Shutting Down")
( page 29)
page
32
46). If the