Panasonic CF-M34 Series Reference Manual page 11

Touchscreen
Configuring the Touchscreen
Events
Set the events that can be generated
by a controller.
Devices
Configure the device controller.
Hardware
Set the hardware resources.
Match this setting with the
setting for [Touch Screen] in
the Setup Utility.
Settings
Set the general protocol set-
tings.
When needed, the touchscreen can be configured using the following steps.
1
Windows 2000
Select from the taskbar or select [Settings] from [Start] -
[Programs] - [UPDD]
Windows XP
Select from the taskbar or select [Settings] from [Start] -
[All Programs] - [UPDD]
The following screen will be displayed.
Advanced
Set the advanced settings.
2
Make necessary changes
3
Select [OK]
NOTE
Adjustments can be made when double-click operations are assumed by the
computer although single-click operations are intended, by clicking [Windows]
from the display shown above and decreasing the value for [Time] in [Double
Click Settings].
Immediately run [Calibrate] when the number of points of calibration is changed.
It is also possible to change the double click speed for [Tap and Buttons]*.
It is important to note that when the double click speed for [Mouse] is changed,
the double click time for [Windows] is also changed.
* Windows 2000 : in [Start] - [Settings] - [Control Panel] - [Mouse].
Windows XP
: in [Start] - [Control Panel] - [Printers and Other Hardware] - [Mouse].
Rotate the display to landscape mode (0 degrees) before performing the calibra-
tion.
General
Set the general settings and functions.
Windows
Set the "double-click" settings.
Calibration
Define the calibration setup.
Use when the cursor can not be pointed
correctly with the stylus. (Needed if the
alignment of the touchscreen with the
visual image change or adjust the dis-
play resolution).
About
Display the version number.
Status
Display the status of the controller.
NOTE
For more information, refer to [Help].
11