Hitachi SF-140SV Operating & Installation Instructions Manual page 27

g
s
How to Install the Washing Machine
* Water supply hose with one-touch joint
1. Loosen the top connector.
Top connector
Fixing screw
●
If the diameter of the tap is larger than the connector ring, remove
the ring.
2. Press up on the top connector so the rubber seal and the tap
are firmly sealed. Next, tighten the 4 screws.
● Rotate the bottom connector so there is no water leakage.
●
Close the tap so you can remove the water supply hose from the
bottom connector. Next, pull off the hose and lower the clasp.
3. Attach the water supply hose to the bottom connector and
lower the clasp.
Water supply hose
■
Make sure the union nut between the water supply hose and the
washing machine is fi rmly tightened.
■
Before operating the washing machine, open the tap to confi rm that the
water supply hose is correctly connected. If the union nut is loose water
will leak.
Connector ring
Top connector
Bottom connector
Rubber seal
Bottom connector
Connector
Rubber seal
Bottom connector
3WPL085661-2
27