System Board - HP Pavilion x2 Detachable Maintenance And Service Manual

4. Loosen the touch board (1), and then lift the board remove it (2).
Reverse this procedure to install the touch board.

System board

Description
System board equipped with an Intel Z8300 1.44-GHz quad core processor (SoC), a graphics subsystem with UMA memory, and up to 2
GB or 4 GB (select products only) of DDR3L 1600 system memory (includes replacement thermal material)
Equipped with a 64-GB eMMC hard drive (SoC) and Windows 10 operating system
Equipped with a 64-GB eMMC hard drive (SoC) and a non-Windows operating system
Equipped with a 32-GB eMMC hard drive (SoC) and Windows 10 operating system
Equipped with a 32-GB eMMC hard drive (SoC) and a non-Windows operating system
Thermal Material Kit (includes replacement thermal material)
Before removing the system board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
5. Remove the battery (see
Remove the system board:
1. Disconnect the following cables from the system board:
(1) Audio jack board cable ZIF connector on the system board (see
30 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Back cover on page 23).
Battery on page 25).
Spare part number
832394-601
832394-001
832393-601
832393-001
826599-001
Audio jack board on page 26)