Table of Contents
Advertisement
Appendix D
Troubleshooting
SEARCHING
FOR BASE
appears on my
cordless handset.
The batteries
will not hold a
charge.
I get noise, static,
or weak signals
even when
I'm near the
telephone base.
• Ensure that the telephone base is powered up.
• Place the cordless handset in the telephone base for
one minute to allow the cordless handset and base to
resynchronize.
• Move the cordless handset closer to the telephone base.
You might have moved out of range.
• Reset the telephone base. Unplug the electrical power.
Wait for 15 seconds then plug it back in. Allow up to
one minute for the cordless handset and telephone base
to reset.
• Other electronic products can cause interference with
your cordless phone. Try installing your phone as far
away from these types of electronic devices as possible:
television sets, VCRs, or other cordless telephones.
• If the cordless handset is in the telephone base or
charger and the charge light does not come on, refer to
The charge light is off in this Troubleshooting guide.
• Charge the battery in the cordless handset for at least
16 hours. For optimum daily performance, return the
cordless handset to the telephone base or charger when
not in use.
• You may need to purchase a new battery. Please refer
to Battery installation & charging, pages 9-10, in this
user's manual.
•
If you subscribe to high-speed Internet service (digital
subscriber line - DSL) through your telephone lines, you
must install a DSL filter between the telephone base and
the telephone wall jack (see page 7). The filter prevents
noise and caller ID problems caused by DSL interference.
Please contact your DSL service provider for more
information about DSL filters.
67
Advertisement
Table of Contents
