Table of Contents
Advertisement
Appendix D
Troubleshooting
My cordless
handset isn't
performing
normally.
The handset
registration is
unsuccessful.
The handset screen
shows PRESS
HNDST LOC 4 SEC
ON BASE and the
handset is out of
the telephone base
or charger.
• Make sure the power cord is securely plugged into
the telephone base. Plug the power adapter into a
different, working electrical outlet not controlled by a
wall switch.
• Move the cordless handset closer to the telephone
base. You might have moved out of range.
• Reset the telephone base. Unplug the electrical power.
Wait for 15 seconds then plug it back in. Allow up to
one minute for the cordless handset and telephone
base to reset.
• Other electronic products can cause interference
to your cordless phone. Try installing your phone
as far away from these types of electronic devices
as possible: television sets, VCRs, or other cordless
telephones.
Follow the steps below to re-register the handset.
1. Make sure the handset is out of the telephone base
or charger and shows NOT REGISTERED before you
begin registration.
2. Press and hold
seconds (until the red IN USE light on the telephone
base is on) and then release the button.
3. Place the unregistered handset into telephone base or
charger.
Refer to the Handset registration section on page 60
for details.
• Unplug the battery from the handset and plug it
back in (page 10). The screen should now show NOT
REGISTERED and you can follow the registration
instructions on page 60.
HANDSET LOCATOR for about four
66
Advertisement
Table of Contents
