Table of Contents
Advertisement
Battery charging
Once you have installed the battery, the screen indicates the battery status (see
the table below).
•
For best performance, keep the handset in the telephone base or
handset charger when not in use.
•
The battery is fully charged after hours of continuous charging.
•
If you place the handset in the telephone base or handset charger
without installing a battery, the screen displays NO BATTERY.
Battery indicators
The screen is blank, or
displays Put in charger
and flashes.
The screen displays
Low battery and flashes.
The screen displays
HANDSET X.
When it is fully charged, you can expect the following performance:
Operation
While in handset use (talking*)
While in speakerphone mode
(talking*)
While not in use (standby**)
* Operating times vary depending on your actual use and the age of the battery.
** Handset is not charging or in use.
Add and register a handset
You can add new handsets (LS6001/LS6001-13/LS6001-15/LS6001-16/LS6001-17,
purchased separately) to your telephone system. Each handset must be registered
with the telephone base before use. When first purchased and properly charged,
each expansion handset alternately displays To register HS... and ...see manual.
The new handset should be charged without interruption for at least 30 minutes
before registering it to the telephone base.
To register a handset:
.
At the bottom of the telephone base, press and hold
/FIND HANDSET for about four seconds until
it shows Registering...
.
On the cordless handset, press
shows Registering... Both the telephone base
and cordless handset show Registered and
you hear a beep when the registration process
completes. The registration process takes about
60 seconds to complete.
Deregister handsets
If you want to replace a handset or reassign the designated handset number of
a registered handset, you must deregister all handsets and then deregister each
handset individually.
To deregister all handsets:
.
Press and hold /FIND HANDSET at the bottom of the telephone base for
about 0 seconds until the telephone base shows Registering... then
De-register?
.
Immediately press /FIND HANDSET again. You hear a confirmation tone.
3.
All handsets alternately show To register HS... and ...see manual. The
deregistration process takes about 0 seconds to complete.
Battery status
The battery has no or very
little charge. The handset
cannot be used.
The battery has enough
charge to be used for a
short time.
The battery is charged.
Operating time
Up to 7 hours
Up to 3.5 hours
Up to 5 days
then it
3
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(about 30 minutes).
To keep the battery charged,
place it in the telephone base
or charger when not in use.
Advertisement
Table of Contents
