Step Recording; Style Assembly - Yamaha PSR-S750 Reference Manual

Step Recording

This section applies to Step 4 of the Basic Procedure on
settings on the BASIC page, call up the STEP RECORD display via the instructions below, then execute Step
Recording.
1) From the BASIC page, while holding down the [F] (REC CH) button, press one of the [1
buttons to select the desired channel as Record target.
2) Use the TAB [F] button to call up the EDIT page.
3) If the "SYS/EX." is shown at the position corresponding to the [F] button, press the [F] button to call up
the Channel Edit display.
4) Press the [G] (STEP REC) button to call up the STEP RECORD display.
The Step Recording procedure in the Style Creator is essentially same as that in Song Creator
the exception of the following points:
• Unlike in Song Creator, the End Mark position cannot be changed in the Style Creator. This is because set-
ting the Pattern Length on the BASIC page determines the End Mark position. For example, if you select a
Section of four measures or you set the Pattern Length to "4" on the BASIC page, the End Mark position is
automatically set to the end of the fourth measure, and cannot be changed.
• Unlike in Song Creator, a Recording channel can be set on the BASIC page. It cannot be set on the EDIT
page.
• Unlike in Song Creator, Chord and Lyrics data cannot be entered. This is because such data is not necessary
for Style playback.
For instructions on Step Recording, refer to
List display in Song Creator), refer to

Style Assembly

This allows you to copy channel data as a Source Pattern from another preset Style to the currently created
Style. Use this function if you find a favorite rhythm pattern, bass line, chord backing or phrase from another
Style.
The instructions below apply to Step 4 of the Basic Procedure on
other settings on the BASIC page, execute the instructions below.
NOTE An Audio part cannot be copied from another Style.
NOTE If you select an Audio Style as starting data, the Audio part cannot be replaced with different data.
1
Call up the operation display.
[FUNCTION] [F] DIGITAL REC MENU
2
If necessary, select the Section to be edited.
Even if the Section to be edited has already been selected on the BASIC page, you can change the Section
also on this page. Press the desired Section button on the panel to call up the SECTION window, use the
[6 ]–[7 ] buttons if you want to select a Fill in, then press the [8
the selection.
page 28. After selecting a Section and make other
pages 52–55. For information on the EDIT page (called as Event
page 65.
page
[B] STYLE CREATOR
]–[8
(page
28. After selecting a Section and make
TAB [E][F] ASSEMBLY
] (OK) button to actually enter
PSR-S950/S750 Reference Manual
]
52) with
2
33