Preparing The Machine; Attaching The Foot Control; Thread Stand - JUKI MO-114D Instruction Manual

Preparing the machine

Polarized For UL, CSA
Polarized power
supply socket
7

Attaching the foot control

Plug foot control into the machine socket (A) and then into the main
socket (B). The foot control regulates the sewing speed. The sewing
speed can be adjusted by increasing or decreasing the pressure on
the foot control.
"WARNING"
This appliance has a polarised plug (one blade wider than the oth-
er). To reduce the risk of electrical shock, this plug is intended to fit
into a polarised main socket only one way. If the plug does not fit
fully in the polarised main socket, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper polarised main
socket. Do not modify the plug in any way.(for USA, Canada only).
* Use only the foot control model YC-482 (USA, Canada), YC-483N
(220-240V).

Thread stand

Push the support rod firmly into the socket on the back of the ma-
chine. Raise the support rod (C) fully, turning slightly until the po-
sition catches engage. Position the thread guide (D) on the thread
stand so that the arrow is to the front.