Display Panel, Non-Touch - HP proone 400 g2 Maintenance & Service Manual

Display panel, non-touch

IMPORTANT:
any old parts. Return all old parts to HP for warranty processing.
CAUTION: it is very important to use the exact cable that shipped with the replacement panel. Failure to use
the correct cable may result in panel failure.
To remove the display panel:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the optical drive (see
6. Remove the system board shield (see
7. Remove the heat sink (see
8. Remove the speakers (see
9. Remove the top trim (see
10. Remove the right trim (see
11. Remove the rear I/O cover and bottom trim (see
12. To separate the bezel from the main frame, remove the two Torx screws that secure the bezel to the
frame (1).
13. Disengage the tabs along the sides that secure the bezel to the frame. Tabs are as follows:
(2) 5 tabs along the left side
(3) 6 tabs along the top
(4) 3 tabs on the right side (1 tab under system board (5))
14. Remove the speaker wire from the routing path on the bottom of the bezel (5).
Install the new display panel together with all other parts in the replacement kit. Do not reuse
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
Replacing the optical drive on page
Heat sink on page
Speakers on page
Top trim on page
Right trim on page
Preparing to disassemble the computer on page
23).
28).
System board (EMI) shield on page
46).
54).
34).
60).
Rear I/O cover and bottom trim on page
24).
31).
37).
64).
Display panel, non-touch
22).
65