Rear I/O Cover And Bottom Trim - HP proone 400 g2 Maintenance & Service Manual

Rear I/O cover and bottom trim

The rear I/O cover and bottom trim is located below the stand on the bottom rear of the computer. It is
secured with two screws.
To remove the rear I/O cover and bottom trim:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Remove the rear port cover (see
4. Remove the stand (see
5. Remove the serial/PS2 board (see
6. Remove the top trim (see
7. Remove the left trim (see
8. Remove the right trim (see
9. Remove the two screws (1) that secure each foot to the computer, and then remove the feet (2).
NOTE:
10. Remove the two screws (2) that secure the rear I/O panel and bottom trim, and then rotate it off the
computer (3).
NOTE:
To replace the rear I/O panel, reverse the removal procedures.
64 Chapter 4 Removal and Replacement Procedures
Access panel on page
Rear port cover on page
Attaching and removing a stand on page
Top trim on page
Left trim on page
Right trim on page
The left foot is shown in the following image.
Callout (1) in the following image shows the location of the screws that secure the feet.
Preparing to disassemble the computer on page
28).
23).
Serial/PS2 board on page
34).
62).
60).
24).
52).
22).