Pjd6531W Lamp Specification - ViewSonic PJD6531w Service Manual

1.3 PJD6531w Lamp Specification

Product Scope
The product is a lamp system consisting of a short arc burner within a reflector and electronic lamp
driver.
Type lamp
Type driver
The lamp must be operated with the OSRAM lamp driver only.
Initial Characteristics
Input Voltage
Standby(non-operating)
Max. input voltage ripple
Max. input current ripple
Input Wattage
Input Wattage standby operation
Output Wattage
nominal
DIM mode
controlled by UART
Output current limitation
Ignition pulse
Ignition Phase Duration
Enable-Disable-Enable Cycle
Acoustic sound pressure level
Acoustic sound power level
Switch-off lamp voltage
Cooling method
Thermal Protection
Safety Protections
ViewSonic Corporation
P-VIP 230/0.8 E20.8 open type
Identcode :
PT VIP O3 MID(230W)-UNISHAPE
Identcode : A581 152 (lock type,Gen5,VC) or
nominal
380V DC
30V @ 100-120Hz
pp
1Ar ms@40-300kHz
max.260W@230W lamp wattage
1, 7W type@380V DC
230W
1 90W
190W...230W in step with of 1/128 of nominal power
4.0 A(RMS)
typ.2.6kVpeak symm.
typ.3. 5s
15 s mi nimum
typical acoustic sound pressure level 36 dB(A),maximum
38dB(A) at 25cm measuring distance; measured in ste ady
8
state lamp operation
typical acous tic sound power level 32 dB(A) acc. to EN ISO
3744; measured in steady state lamp operation
140V
forced air cooling at
Tc1 switch point 90
The lamp connections are not mains isolated, The lamp
can be switched on via the Start Control Input signal(SCI).
9
A 598 09C
A581 146 (lock type,Gen5,VC,DL) or
A584 924(lock type,Gen5,VC,HF)
tolerance
320...400V DC
120...400V DC
7
3%
6
3%
5%
2.4 ...3.5 kVpeak
max.6 s
5V
1.5 m/s minimum
5
Confidential - Do Not Copy
7
PJD6531w