Intel I430 VX User Manual page 13

3-7.
POWER MANAGEMENT SETUP
ROM PC1 BIOS
POWER MANAGEMENT SETUP
AWARD SOFT\
Power Management
PM Control By APM :Yes
Video Off Method
MODEM USE IRQ
Doze Mode
Standby Mode
Suspend Mode
HDD Power Down
IRQ3 (Wake-Up Event) :ON
:ON
IRQ4 (Wake-Up Event)
:ON
:ON
POWER MANAGEMENT:
Disabled
their MAX . value
Max.Saving :Pre-define timer values are used such that all timers are in
their MlN value.
PM Control by APM:
NO : System BIOS will ignore APM.
Yes : System BIOS will wait for APM's prompt before it
enter any PM mode, e.g. DOZE, STANDBY or SUSPEND.
the BIOS to put the system into any power saving mode!
2. IF APM is not installed this option has no effect.
PAGE 20
CHAPTER 3. BIOS SETUP
ARE, INC.
:ON
IRQ3 (COM 2)
:ON
IRQ6 (Floppy Disk) :Off
IRQ7 (LPT 1)
:Off
IRQ9 (lRQ2 Redir) :Off
IRQ 10 (Reserved)
IRQ 11 (Reserved)
IRQ12 (PS/2 Mouse) :Off
:ON
IRQ 15 (Reserved)
ESC :
Quit
(Shift) F2 : Color
F6 : Load Bios Defaults
F7 : Load Setup Defaults
Video Off Method
Blank Screen : The system BIOS will only blanks off the screen when
disabled.
V/H SYNC+Bhmk : BIOS will also turn off the V/H SYNC signal from VGA
card to monitor.
DPMS
Doze Mode
Standby Mode
Suspend Mode
HDD Power Down
Wakeup Event
Any activity. The system will wake up.
Power down Activities : To COM ports, LPT ports and Drive ports
IRQ3.. . . .IRQ 15 check point Then Into Green function.
3-8. PNP / PC1 CONFIGURATION SETUP
ROM PC1 BIOS
PNP / PC1 CONFIGURATION SETUP
AWARD SOFTWARE, INC.
: Yes
Zest Configuration Data : Disables
Slot (l-3) Using INT# : Auto (A, B, C, D)
(1-3) Available IRQ
Primary IDE INT#
Secondary IDE INT#
PAGE 21
CHAPTER 3. BIOS SETUP
Primary IDE Int# :A
Secondary IDE Int# :B
ESC : Quit
(Shift) F2 : Color
F6 : Load Bios Defaults
F7 : Load Setup Defaults