Acer AcerPower Flex4000 Series User Manual page 101

5. Select the 'Boot Options' section, and change the 'Boot Sequence' to the following
order:
st
1 [CD-ROM]
nd
2 [Floppy Disk]
rd
3 [Hard Disk]
6. Press ESC twice. When prompted, 'Do you want to save CMOS data?', select [Yes],
then press ENTER. The system will reboot from the CD-ROM.
7. After booting from the CD-ROM, you will see the Acer CPR options displayed. Select
Rebuild Drive and follow the onscreen instructions.
8. When prompted, use the DS number (DS.xxxxx.xxx) found on a label located on the
lower right side of your system chassis, to select the correct software installations.
9. After you complete rebuilding your hard disk drive, remove your Acer Resource CD
and repeat steps 2, 4, 5, and 6 to enter CMOS setup. Set the 'Boot Sequence' back to
its original configuration:
st
1 [Floppy Disk]
nd
2 [Hard Disk]
rd
3 [CD-ROM]
10. After the hard disk rebuilding process completes, remove your Acer Resource CD.
11. Look for your Microsoft Certificate of Authenticity (COA) ID number on the cover of
your Windows 95/NT manual. Enter this number when requested.
Index