Adjust Discharge Chute Deflector; Lever; Adjust Discharge Chute; Adjust Speed Selector Lever - Ariens 920021-Compact 24 LE Operator's Manual

ADJUST DISCHARGE CHUTE

DEFLECTOR LEVER
See Figure 23.
If deflector does not stay in selected position,
tighten the nut under the control panel.
Figure 23
If deflector does not follow full range of travel:
1. Position deflector control in the rear-most
position.
2. Adjust nuts on chute cable. See
Figure 24.
• To adjust deflector lower, loosen lower
nut and tighten upper nut.
• To adjust deflector higher, loosen upper
nut and tighten lower nut.
2
3
1. Chute Cable
2. Upper Adjustment Nut
3. Lower Adjustment Nut
Figure 24
ADJUST DISCHARGE CHUTE
See Figure 25.
If discharge chute does not stay in selected
position, tighten nut on carriage bolt.
ADJUST SPEED SELECTOR

LEVER

See Figure 26.
1. Disconnect adjustment pivot pin from
speed selector arm. Save hardware for
reinstallation.
2. Position speed selector lever in fastest
forward position.
3. Turn speed selector arm down as far as it
will go.
4. Model 920021: Thread adjustment pivot
pin along shift rod until it aligns with the
mating hole on the speed selector arm,
and then turn it up the shift rod 7 turns.
Insert pivot pin into the hole.
1
5. Model 920022: Thread adjustment pivot
pin along shift rod until it aligns with the
mating hole on the speed selector arm,
and then turn it up the shift rod 3 turns.
Insert pivot pin into the hole.
6. Connect pivot pin to speed selector arm
with hardware removed in step 1 and
check forward and reverse speeds.
a. Start unit, position speed selector
b. Stop unit, position speed selector
c. Stop unit. If unit does not travel
EN - 17
Figure 25
lever in the first forward position and
engage traction drive clutch. Unit
should move forward.
lever in the first reverse position and
engage traction drive clutch. Unit
should move in reverse.
correctly, repeat adjustments.