Adjust Discharge Chute Deflector Lever; Adjust Discharge Chute; Adjust Speed Selector Lever - Ariens Sno-Thro Professional Pro 28 Operator's Manual

ADJUST DISCHARGE CHUTE

DEFLECTOR LEVER
See Figure 23.
If deflector does not stay in selected position,
tighten the nut under the control panel.
Figure 23
If deflector does not follow full range of travel:
1. Position deflector control in the rear-most
position.
2. Adjust nuts on chute cable. See
Figure 24.
• To adjust deflector lower, loosen lower
nut and tighten upper nut.
• To adjust deflector higher, loosen upper
nut and tighten lower nut.
1
2
3
1. Chute Cable
2. Upper Adjustment Nut
3. Lower Adjustment Nut
Figure 24
ADJUST DISCHARGE CHUTE
See Figure 25.
If discharge chute does not stay in selected
position:
1. Remove discharge chute gear cover.
2. Loosen rear adjustment nut and tighten
forward adjustment nut until the lock arm
engages the gear teeth.
3. Reinstall gear cover.
If discharge chute does not rotate freely:
1. Remove discharge chute gear cover.
2. Loosen forward adjustment nut and
tighten rear adjustment nut until there is
no cable slack and the lock arm engages
the gear teeth.
3. Reinstall gear cover.
3
2
1. Discharge Chute Gear Cover
2. Rear Adjustment Nut
3. Forward Adjustment Nut
4. Lock Arm
ADJUST SPEED SELECTOR
LEVER
See Figure 26.
1. Disconnect adjustment pivot pin from
speed selector arm. Save hardware for
reinstallation.
2. Position speed selector lever in fastest
forward position.
3. Turn speed selector arm down as far as it
will go.
4. Loosen jam nut on shift rod.
5. Thread adjustment pivot pin along shift
rod until it aligns with the mating hole on
the speed selector arm, and then insert
the pivot pin in the hole.
EN - 17
4
Figure 25
1