Sony MAV-777 Operation Manual page 52

Item number Display indication
633 TCG MODE R1
634 TCG MODE R2
635 TCG MODE R3
BI
SUBMENU
ID CODE PRESET
REGEN MODE
REGEN / PRESET
INT / EXT
REC RUN / FREE RUN
REGEN SOURCE
BINARY GROUP
636 REC VITC SELECT R1
637 REC VITC SELECT R2
638 REC VITC SELECT R3
BI
645 PB VITC POSITION P1
646 PB VITC POSITION P2
647 PB VITC POSITION P3
BI
SUB MENU
SELECT 1
SELECT 2
673 LTC SELECT R1
674 LTC SELECT R2
675 LTC SELECT R3
BI
676 PB TC REPLACE P1
677 PB TC REPLACE P2
678 PB TC REPLACE P3
BI
3-28 (E)
3-4 Setup
Expansion menu items (Continued)
Settings Description
Sets the Time Code Generator.
Sets whether the ID CODE is registered.
USER BIT : Registers the USER BIT without registering the ID CODE.
ID CODE : Registers the ID CODE.
Selects the regenerate signal when the Time Code Generator is in the regenerate mode.
TC : Only TC is regenerated.
UB : Only UB is regenerated.
TC & UB : Regenerates TC and UB.
Sets whether Time Code Generator regenerates.
REGEN : Regenerates the time code.
PRESET : Does not regenerate the time code.
Determines whether the time code generated by the time code generator, or whether the
externally supplied time code is used for the record time code.
INTERNAL : Time code generated by the Time Code Generator is used.
EXTERNAL : Externally supplied time code is used.
Sets the timing for the start of transfer of the TCG regenerate.
REC RUN : Transfer starts with REC.
FREE RUN : Normal transfer.
Sets the TC for generation of the original TCG.
LTC : Generates from the LTC.
VITC : Generates from the VITC.
Sets the user bit specifications of the time code generated by the Time Code Generator.
000 : not specified
001 : ISO character
010 : unassigned-1
011 : unassigned-2
100 : unassigned-3
101 : page/line
110 : unassigned-4
111 : unassigned-5
Sets whether the time code can be output from the VITC time generator when recording
is loaded.
on : Switches to the VITC of the time code generator.
off : Records the VITC of the input signal.
These items select two lines for inserting VITC during playback.
10 Line .. 16 Line .. 18 Line
Note:
This setting is effective with down-convert output only.
Specifies the timecode that is used as the LTC input.
SYSTEM TC : Selects the timecode input at the TIME CODE IN SYSTEM connector.
LINE INPUT : Selects the timecode that is input to the TIME CODE IN R1 (or R2)
connector.
Embedded : Selects the LTC timecode of the signal that is input to the HD SDI IN
connector.
Note: With 3 input/1 output configuration, LINE INPUT selection is not possible
for port R3
These items select the data that is output as VITC and LTC during playback.
off : Output VITC and LTC from the recorded material.
LTC : Output LTC from the recorded material for LTC and VITC.
TM2 : Output TM2 from the recorded material for LTC and VITC.
VITC : Output VITC from the recorded material for LTC and VITC.
: Character set not used.
: 8-bit characters in compliance with ISO646, ISO2022
: Undefined
: Undefined
: Undefined
: SMPTE262M Page/Line Multiplex System
: Undefined
: Undefined
.. 19 Line