Table of Contents
Advertisement
The Ethernet Switch can be installed quickly and easily. However, for an installation with minimum impact on the existing
network, please read this chapter carefully.
Installing a Ethernet Switch involves three steps:
1. Choosing a location
2. Supplying power
3. Connecting the switch
Choosing A Location
The location of the switch is based on the following criteria:
u
Avoid dusty locations.
u
Avoid electromagnetic noisy areas, such as locations close to power transformers or radio transmitters.
u
Avoid temperatures below 32 Degrees Fahrenheit and over 122 Degrees Fahrenheit.
u
Allow a clear view of the front panel LED indicators.
u
Allow easy access to the front panel ports and the rear panel switches.
After choosing an appropriate location, you can install the switch on a desktop or in a rack.
Rack Installation
Your switch comes with two rack mounting brackets. You can use these brackets to mount the switch on an EIA standard 19"
rack. Attach the brackets to the switch, using the screws provided.
Next, install the switch in the rack using the screws provided to attach the brackets to the rack.
Supplying Power
The Ethernet Switch is equipped with a universal switching power supply that accepts AC input voltages from 100 to 240VAC
and 50 to 60 Hz.
To supply power to your switch:
u
Plug the connector of the power cord into the power port on the rear panel of your switch.
u
Plug the other end of the power cord into an AC wall outlet.
u
Set the power switch to ON and verify that the Power LED is lit. If it is not, check the following:
1. The power switch is in the ON position.
2. The power cord is properly connected to the wall outlet and to the power connection on the switch.
3. The wall outlet is functional.
Note:
Network cable segments can be connected or disconnected from the switch while the power is on, without interrupting the
operation of the switch.
Figure 4-1. Attaching self-adhesive feet for desktop installation
Figure 4-2. Attaching the mount brackets for rack installation
Chapter 4
Installation
Advertisement
Table of Contents
