Planet FGSW-1602 User Manual page 12

Four Ports 100Base-FX Fiber Module –
Figure 2-7. 4 port 100Base-TX/FX Front View
When installed into a Ethernet Switch, this Module provides 4 x 100Mbps Fast Ethernet fiber ports which can be used to:
♦
Connect the Switch to the backbone of your network; that is, to a basement switch, hub or router.
♦
Connector the Switch to a 100Mbps server or end station.
A ST (or SC) connector provides the link to the multi-mode fiber cabling and three LEDs show five status of the Module at-a
glance. A DIP-switch sets the operating mode to half duplex or full duplex (default).
The following Table2-3. lists the ports operating modes based on the DIP switch position.
PORT 1
SW 1
ON Half-Duplex Half-Duplex
OFF Full-Duplex Full-Duplex
Table 2-3. Four ports 100Base-FX Fiber Module DIP switch functions
(1) Four ports 100Base-FX Fiber Module Feature
♦
Conforms to IEEE 802.3u Fast Ethernet standard
♦
Support SC or ST fiber connector (optional)
♦
Support half and full duplex via DIP switches
♦
Store-and-forward switch architecture for abnormal packets filtering
♦
Backplane up to 2.4Gbps
♦
Automatic address learning with 12K address entry storage
♦
Filtering and forwarding rate 148,800 packets per second for 100Mbps
♦
100Base-FX uses 62.5/125 micron multi-mode fiber
1000Base-SX/LX Fiber Module —
Figure 2-9. 1000Base-SX/LX Front View
When installed into a Ethernet Switch, the 1000Base-SX/LX Module provides 1 Gigabit Ethernet ports which can connect the
Switch to a Gigabit Backbone Switch or Server with Gigabit NIC.
FGSW-4ST/4SC
Port 1
Port 2
DIP Switch Location
Port 3
Port 4
Figure 2-8. Location and setting duplex mode
PORT 2 PORT3
2 3
Half-Duplex
Full-Duplex
FGSW-1SX/1LX
PORT4
4
Half-Duplex
Full-Duplex