Software (Firmware) Update - Panasonic Diga DMR-EX97 Operating Instructions Manual

Convenient functions

Software (Firmware) Update

You cannot operate the unit until the update
is complete. Don't remove the AC mains lead
during the update. Removing the AC mains
lead while the update is in progress may
damage the unit.
Update software (firmware) of this unit
Software of this unit can be updated automatically
by the following methods at the specified time.
• From broadcasts
(Default setting is 3 a.m.
Update in Standby)
• From Internet
Network connection and setting are required.
( 15, 17)
If a software (firmware) update is available, a
notification is displayed.
New software version has been found.
The software will be updated automatically
after this unit is switched to standby.
Do not disconnect the AC mains lead.
Update of the software (firmware) will start when
the unit is turned to standby mode.
68
SQT0994
67, Software
To update the software (firmware)
immediately
Use the "Software Update Now ( Broadcast )"
function or "Software Update Now ( Internet )"
function. ( 67)
• It may take up to a few hours until the update is completed
depending on the network environment.
• The timer recording always takes preference over the
software (firmware) download; if the timer recording is
scheduled to start, the downloading will be performed at the
next opportunity.
• For the latest firmware update information, please refer to
the Panasonic support site below.
• You can also download the latest software (firmware) from
the following website.
http://panasonic.jp/support/global/cs/