Panasonic Diga DMR-EX97 Operating Instructions Manual page 17

5
Set the Owner ID-Data Entry ("NAME",
"HOUSE NO" and "POSTCODE").
e.g.,
Owner ID-Data Entry
PIN 0000
NAME
HOUSE NO
POSTCODE
Select
Change PIN
RETURN
1 Select the item, then press [OK].
2 Select the character, then press [OK].
Repeat this step.
3 Press [BACK/RETURN
4 Repeat steps 1-3 to enter all data.
5 Press [BACK/RETURN
the Owner ID-Data Entry screen.
6
Enter the new PIN for parental control.
PIN Entry
Enter a new 4-digit PIN, then press OK.
This PIN will be used for controlling viewing and playback.
PIN will be set to "0000" by pressing "RETURN" when there is no
number input.
- -
RETURN
• The default PIN is "0000".
1 Enter the new 4-digit PIN with the number
buttons.
• Make a note of the PIN you have
decided on in case you forget it.
2 Press [OK].
7
Set "Quick Start" to "On", "Off" or "Timer
Setting for Quick Start", then press [OK].
For details, refer to "Quick Start". (
When "Easy Setting has been completed."
appears, Easy Setting is complete.
- Select "Yes" to set network settings.
- Select "No" to finish the Easy Setting.
].
] to exit from
- -
Number 0 9
66)
To stop partway
Press [BACK/RETURN
To restart setup ( 61, Auto Setup)
To display the Owner ID information on TV
1 While the unit is on, press and hold [OK], the
yellow button and the blue button on the
remote control at the same time for more than
5 seconds.
- "00 RET" is displayed on the front panel
display.
2 Repeatedly press [1] (right) on the remote
control until "01 OID" is displayed on the front
panel display.
3 Press [OK] on the remote control.
The PIN is not displayed.
To change PIN for parental control
Refer to "PIN Entry". (
To change the region for Channel Sorting
Refer to "Channel Sorting by Region". (
• If tuning is cancelled partway through, it may not be
possible to receive the channels. Restart setup again.
Easy Network Setting
After completing "Easy Setting", you can continue
with "Easy Network Setting".
Follow the on-screen instructions and make the
following settings.
When "Easy Network Setting is finished." appears
Press [OK].
Getting started
].
67)
61)
17
SQT0994