Software (Firmware) Update - Panasonic Diga DMR-XW390 Operating Instructions Manual

Convenient functions

Software (Firmware) Update

You cannot operate the unit until the update
is complete. Don't remove the AC mains lead
during the update. Removing the AC mains
lead while the update is in progress may
damage the unit.
Software of this unit can be updated automatically
by following method in standby mode at the
specified time.
(Default setting is 3 a.m.
in Standby)
- From broadcasts
- From Internet
§
Network connection and setting are required.
§
( 15, 18)
If a software (firmware) update is available, a
notification is displayed.
New software version has been found.
The software will be updated automatically
after this unit is switched to standby.
Do not disconnect the AC mains lead.
• It is displayed on the channel information (
when the software (Firmware) can be updated
immediately.
e.g.,
1
Dogs and Cats
9:00 - 11:00
Now
Rating: PG HE-AAC
To execute, push the red button while the
channel information is displayed, and follow the
instructions on the screen.
Update of the software (firmware) will start when
the unit is turned to standby mode.
80
VQT4C72
78, Software Update
21)
All Digital Channels
10:30
Select favourites
Software upgrade
The unit's display during the update
e.g.,
• When "FINISH" is displayed, update of the
software (firmware) has completed.
• It may take up to a few hours until the update is completed
depending on the network or broadcast environment.
• The timer recording always takes preference over the
software (Firmware) download; if the timer recording is
scheduled to start, the downloading will be performed at the
next opportunity.
• You can also download the latest software (firmware) from
the following website.
http://panasonic.jp/support/global/cs/